|
|
#11
03-02-18, 03:56
|
||||
|
||||
Hi Lynn, Hijack away
 I have made a solid table top for temporary use of keeping my bearing surfaces flat. I have used some 20mm plate I had here so I can use it again when finished. I have a centre and a diameter finder and some instant clamps for keeping it all together while the process is complete and slow cooling. I think I can cut the internal gear on my plasma and that will be a fantastic saving and a quick process. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Door Resto | Barry Churcher | The Restoration Forum | 13 | 15-05-22 15:36 |
| FAT cab 13 No 9 resto | Mrs Vampire | The Softskin Forum | 27 | 29-09-21 06:11 |
| C15A resto | harrygrey382 | The Restoration Forum | 9 | 08-06-15 09:40 |
| another CAN m37 resto | Steve Wilson | The Restoration Forum | 11 | 25-08-12 15:57 |
| m 37 resto in new brunswick | pauljboudreau | Post-war Military Vehicles | 118 | 07-03-11 22:29 |
Threaded Mode