|
|
#11
03-02-18, 06:40
|
||||
|
||||
Hi Bob, I have to weld two rings on top and the top one having a internal gear all round. Then I need to put the whole thing in my milling machine and cut a 3/4" grove the full distance around the top. The photos below show the first one welded and ground off and I had a prelim try at cutting gears on my plasma. I am quite happy with the result but I need to make time on the computer and draw a curved toothed ring for the last top section. There will be a bit of trial and error on that part I think. I am very happy with the result of the ring so far.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Door Resto | Barry Churcher | The Restoration Forum | 13 | 15-05-22 15:36 |
| FAT cab 13 No 9 resto | Mrs Vampire | The Softskin Forum | 27 | 29-09-21 06:11 |
| C15A resto | harrygrey382 | The Restoration Forum | 9 | 08-06-15 09:40 |
| another CAN m37 resto | Steve Wilson | The Restoration Forum | 11 | 25-08-12 15:57 |
| m 37 resto in new brunswick | pauljboudreau | Post-war Military Vehicles | 118 | 07-03-11 22:29 |
Threaded Mode