|
|
#11
07-03-18, 07:20
|
||||
|
||||
The material for the base is 20mm thick and apart from milling them into a perfect circle I also had to divide them in 8 sections and them machine a bevel at each section. I assume it is for water run off or something. The rod you can see is 40mm dia which is machined and recessed into the base plate. I still need to slot the rods for the cupola sides. These little things are about as much work as the turret that they sit on. At least by the time I get my curved plated I should have these done so that's a good start.
Last edited by colin jones; 07-03-18 at 20:03. Reason: Re-orientate photo 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Door Resto | Barry Churcher | The Restoration Forum | 13 | 15-05-22 15:36 |
| FAT cab 13 No 9 resto | Mrs Vampire | The Softskin Forum | 27 | 29-09-21 06:11 |
| C15A resto | harrygrey382 | The Restoration Forum | 9 | 08-06-15 09:40 |
| another CAN m37 resto | Steve Wilson | The Restoration Forum | 11 | 25-08-12 15:57 |
| m 37 resto in new brunswick | pauljboudreau | Post-war Military Vehicles | 118 | 07-03-11 22:29 |
Threaded Mode