|
|
#11
09-07-18, 04:26
|
||||
|
||||
I am going to fabricate the bearing housings, weld and machine the excess off after completion. I need two more for the other tank but will wait until I decide what type of drive system will be suitable. after I weld in the boss, I will be able to lathe the outside perimeter down to size. The holes that are in the dish at the moment will be machined off and new holes put in the correct locations.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Door Resto | Barry Churcher | The Restoration Forum | 13 | 15-05-22 15:36 |
| FAT cab 13 No 9 resto | Mrs Vampire | The Softskin Forum | 27 | 29-09-21 06:11 |
| C15A resto | harrygrey382 | The Restoration Forum | 9 | 08-06-15 09:40 |
| another CAN m37 resto | Steve Wilson | The Restoration Forum | 11 | 25-08-12 15:57 |
| m 37 resto in new brunswick | pauljboudreau | Post-war Military Vehicles | 118 | 07-03-11 22:29 |
Threaded Mode