Info needed: Chevrolet timber tray brackets

[Davistine Liddle]

Originally Posted by Mike Cecil

Shaun,

You don't have to post the same thread in multiple places - we'll generally see it no matter where it is.

Tony: I think he's wanting the smaller tie down hooks, about 3 inches long, 3/4 inch wide flat, two counter-sunk screw holes, with a shaped hook at one end. I remember two types: one with the hook part shaped from the flat and bent back over to make the hook, such as a blacksmith would do, and a fabricated type with a round welded to the end of the flat, and bent back to make the hook. Used to lace down the bottom edge of the canopy.

I think the hook you show is the hook for holding the folded back flap on the early canopy type where the sides wrapped back part way across the rear of the tray, or on the side on later vehicles for holding the rear canopy flap in the closed position. Much more robust than the smaller canopy tie-downs as shown in the second image. (Shaun probably needs both).

Mike

i think he wants this

[Shaun Mastin]

Thanks for the replay very helpful, think your right mike ,
, I thought they would have been more the the Jeep trailer hooks but I guess there different

[Shaun Mastin]

Yes I do need both type of the hooks

[Tony Mathers]

hook1.jpg hook2.jpg

measurements

[Shaun Mastin]

Thanks heaps ,

Would anyone have any of these for sale ?

[Shaun Mastin]

What’s the thickness of the top hook ?

Originally Posted by Tony Mathers

Attachment 105494
Attachment 105495

measurements

[Tony Mathers]

Originally Posted by Shaun Mastin

What’s the thickness of the top hook ?

you mean the loop? I will measure tomorow, or if you are near kyneton you can come and check yourself. I need some more too, so no I have none to spare...

[jack neville]

Get them laser cut and shape to suit.

[Shaun Mastin]

Originally Posted by Tony Mathers

Attachment 105494 Attachment 105495

measurements

Those hooks that go sideways that are 4cm , how many are there on the tray itself