Wanted: c42 fender bracket

[Wayne Hingley]

Hi Eric. Per Rob's comments, the bracket has angled mounting points for the 3/4 ton where it fits the arch of the front fender. Even if those were fattened out, the center to center hole dimension wouldn't change noticeably from the 9-1/2" dimension mentioned previously.

See photos; the overall height is 8-3/4", and the flat top dimensions are 5-1/2" x 8".

UPDATE - After rechecking, I agree with Brian's hole dimension of 6-1/2", and after removing the old bolt, my height measurement is closer to 8-5/8", but that could be the difference on how much the lower tabs are angled vs Brian's. Assuming Brian has a NOS example, his measurements are probably more correct.