![]() |
|
#1
|
|||
|
|||
![]()
Pity you are in Australia (or that I'm not!) as I have a set of eight new 3 5/16", 4-ring pistons & pins and rings 'surplus to requirements'.....
Plus a 1/2 set of 4 new 3 3/16" pistons and rings .... (don't ask me why!!!) Anyone in the USA or Canada in need of a set? Mike |
#2
|
|||
|
|||
![]()
Engine stand slowly taking shape!
|
#3
|
|||
|
|||
![]()
Hi everyone, so I pulled the F60L (high and low with pot)Tx case apart. I knew that the intermediate shaft fwd bearing had failed, but the damage was worse than expected. The gears appear to be ok, but the main TX case has been chewed out. Does anyone have a similar photo showing the casting, so that I can make a comparison?
I need to decide if to replace the entire housing....I have a F15 Tx case in case somebody wants to swap! What are people’s thoughts on the damage? Last edited by David Nicholson; 25-10-17 at 20:14. |
#4
|
||||
|
||||
![]()
I have one pulled apart at the new property, I can take pictures on Sun. if no one beats me.
__________________
Robert Pearce. |
#5
|
||||
|
||||
![]() Quote:
Cheers, Ian http://www.mapleleafup.net/forums/sh...172#post237172
__________________
Ian Williams F15A, 2x Army Land Rover 88' sIIA's GPW Other stuff |
#6
|
||||
|
||||
![]()
I'll have to look on Sunday, I am 90% shore it is a Ford case. It is available if wanted.
__________________
Robert Pearce. |
#7
|
||||
|
||||
![]()
Case is Ford, I also have another with all the cogs in but with the PTO blanked off.
__________________
Robert Pearce. |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Door Resto | Barry Churcher | The Restoration Forum | 13 | 15-05-22 15:36 |
FAT cab 13 No 9 resto | Mrs Vampire | The Softskin Forum | 27 | 29-09-21 06:11 |
C15A resto | harrygrey382 | The Restoration Forum | 9 | 08-06-15 09:40 |
another CAN m37 resto | Steve Wilson | The Restoration Forum | 11 | 25-08-12 15:57 |
m 37 resto in new brunswick | pauljboudreau | Post-war Military Vehicles | 118 | 07-03-11 22:29 |