For Sale: Ford CMP gearstick boots (reproduction)

[Andrew Rowe]

Hi Keith,
Is a similar boot used on the HI / Low , 2WD & 4WD Shifter housing?
Do You know if it is the same size? Cheers Andrew.

[Keith Webb]

Originally Posted by Andrew Rowe

Hi Keith,
Is a similar boot used on the HI / Low , 2WD & 4WD Shifter housing?
Do You know if it is the same size? Cheers Andrew.

From memory I don't recall seeing one intact on the transfer case lever - it would be a different shape though.

[Keith Webb]

Originally Posted by Keith Webb

From memory I don't recall seeing one intact on the transfer case lever - it would be a different shape though.

It looks like it did once have one but I have no reference image unfortunately.

There is a retaining piece. This is on a FGT.

[Andrew Rowe]

Hi Keith, just for reference, because my cunning plan was to see if your boots would interchange on the transfer case housing shifter. Someone else might have an original boot for this housing to clarify the different types?.Cheers Andrew .

[Keith Webb]

Hi Andrew

Is your photo from a Chevrolet? It's different to the one in the FGT. The actual tower does not protrude a lot on the cab 13 - the cab 11/12 tower comes a lot further into the cab.

Originally Posted by Andrew Rowe

Hi Keith, just for reference, because my cunning plan was to see if your boots would interchange on the transfer case housing shifter. Someone else might have an original boot for this housing to clarify the different types?.Cheers Andrew .

[Andrew Rowe]

It was from a Ford, C29QR ( Rear engined Chassis ), but the tower is common on Fords I believe , but just mounted different in the rear engine chassis configuration, Andrew.

[Lynn Eades]

Andrew, there is a tower weather pad "C291QR 8111125.
Pad-transfer case shifter control tower weather" No other info.
I would assume "pad" means a flat item (leather?) as opposed to a rubber boot.